How To Wind a Video Balun

Winding a video balun is not as hard as it sounds. You can, in fact, use household tools to do so. In this article, we will share with you tips on how to wind a video balun. For this task, you will need a ruler, a wire stripper, the antenna cable to which you want to wind it, some electrical tape and of course, the video balun. You can purchase a video balun from your nearby electronics shop or hardware store. You can also get it from a video balun manufacturer like PIMFG.com.

First, using the wire stripper, strip half an inch of insulation off the ends of the two wires attached to the balun. Now, slit four inches in on the outer insulation at the end of the antenna’s cable. Pull the insulation back to expose the inside of the cable.

Next, push the wire mesh back until it goes back to the uncut insulation of the cable. Carefully twist the mesh between your fingers until you are able to form a rod. Again, using the wire stripper, strip half an inch off the end of the inner wire of the insulation. Now, wind one of the two exposed ends of the wires from the video balun around the rod mesh you created. Wrap a strip of electrical tape around the two wires. Finally, wrap strips of electrical tape along the length of the cable from where the insulation ends up to the back of the video balun.

For more tips on using a video balun, keep reading this blog.


Article Source